Oracle 生成单据编号存储过程

来源：互联网发布：vpn 绕过公司网络监控编辑：程序博客网时间：2024/04/30 05:21

在做订单类似的系统都可能会存在订单编号不重复，或是流水号按日，按年，按月进行重新编号

可以参考以下存储过程

CREATE OR REPLACE
procedure Pro_GetBillNO(TypeTable in varchar2,cur_mycursor out sys_refcursor)
as
DReceiptCode varchar2(40);
DReceiptName varchar2(50);
DPrefix1 varchar2(50);
DISO varchar2(50);
DIsAutoCreate varchar2(20);
DPrefix2 varchar2(20);
DPrefix3 varchar2(20);
DDateValue date;
DNO number;
DLength number;
DResetType number;
DSeparator varchar2(20);
DReturnValue varchar2(50);
strSql varchar2(1000);
begin
DReturnValue:='';
select "ReceiptCode","ReceiptName","Prefix1","ISO","IsAutoCreate","Prefix2","Prefix3","DateValue","NO","Length","ResetType","Separator" into
DReceiptCode,DReceiptName,DPrefix1,DISO,DIsAutoCreate,DPrefix2,DPrefix3,DDateValue,DNO,DLength,DResetType,DSeparator from
"SysReceiptConfig" where "ReceiptCode"=TypeTable;
if to_number(DResetType)>0
then
if DIsAutoCreate=1 THEN
if DResetType=1 then --按年份
if to_number(to_char(sysdate,'yyyy')) <>to_number(to_char(DDateValue,'yyyy')) then
update "SysReceiptConfig" set "NO"=1,"DateValue"=to_date(sysdate) where "ReceiptCode"=TypeTable;
else
update "SysReceiptConfig" set "NO"="NO"+1 where "ReceiptCode"=TypeTable;
end if; --年份
end if;--DResetType=1

if DResetType=2 then --按月份
if to_number(to_char(sysdate,'MM')) <>to_number(to_char(DDateValue,'MM')) then
update "SysReceiptConfig" set "NO"=1,"DateValue"=to_date(sysdate) where "ReceiptCode"=TypeTable;
else
update "SysReceiptConfig" set "NO"="NO"+1 where "ReceiptCode"=TypeTable;
end if; --月份
end if;--DResetType=2

if DResetType=3 then --按日
if to_number(to_char(sysdate,'dd')) <>to_number(to_char(DDateValue,'dd')) then
update "SysReceiptConfig" set "NO"=1,"DateValue"=to_date(sysdate) where "ReceiptCode"=TypeTable;
else
update "SysReceiptConfig" set "NO"="NO"+1 where "ReceiptCode"=TypeTable;
end if; --月份
end if;--DResetType=3

else
update "SysReceiptConfig" set "NO"="NO"+1 where "ReceiptCode"=TypeTable;
end if;--DResetType
end if;

strSql:=' select * from "SysReceiptConfig" where 1=1 ';
strSql:=strSql ||' and "ReceiptCode"='''||TypeTable||'''';

open cur_mycursor for strSql;

end;

0 0