Is it possible to implement IPv6 on a virtual interface (eth0:1 interface) in Linux?

https://unix.stackexchange.com/questions/335894/is-it-possible-to-implement-ipv6-on-a-virtual-interface-eth01-interface-in-li

If I assign an IPV6 address to the virtual interface created likeeth0:1, then it gets automatically assigned to its real interfaceeth0.

It's all working fine on IPv4, but I need IPv6 on the virtual interface as well. I tried everything that worked on the physical interface and I cannot get anything IPv6 to show for theeth0:1 interface.

eth0      Link encap:Ethernet  HWaddr 00:04:9f:02:81:97            inet addr:192.168.1.10  Bcast:192.168.1.255  Mask:255.255.255.0          inet6 addr: fc00:1234:1::10/120 Scope:Global          inet6 addr: fc00:1234:1::70/120 Scope:Global          inet6 addr: fc00:1234:1::42/120 Scope:Global          inet6 addr: fc00:1234:1::40/120 Scope:Global          inet6 addr: fe80::204:9fff:fe02:8197/64 Scope:Link          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1          RX packets:0 errors:0 dropped:0 overruns:0 frame:0          TX packets:36 errors:0 dropped:0 overruns:0 carrier:0          collisions:0 txqueuelen:1000           RX bytes:0 (0.0 B)  TX bytes:5528 (5.3 KiB)          Base address:0xe000 eth0:1    Link encap:Ethernet  HWaddr 00:04:9f:02:81:97            inet addr:192.168.1.40  Bcast:192.168.1.255  Mask:255.255.255.0          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1          Base address:0xe000 

=====================================================================

IPv4 implementations originally only supported one address per interface, which is why virtual interfaces were invented so you can add multiple addresses on the same physical interface.

IPv6 supports multiple addresses per interface by default so there is no need to use virtual interfaces for IPv6. Just add them to the interface itself, the end result is the same.