connect two WiFi simultaneously

https://superuser.com/questions/592296/using-iw-to-add-a-virtual-wireless-interface-getting-the-error-no-such-device

Q:

I am trying to add a virtual wireless interface to my debian squeeze system using iw.

The output of iw list is shown below:

root@alix:~# iw listWiphy phy0

I am using the command:

iw dev phy0 interface add wlan1 type station

to add the virtual interface wlan1 however this gives me the error:

command failed: No such device (-19)

If I use the command:

iw dev wlan0 interface add wlan1 type station

it passes fine however if I try use both wlan0 and wlan1 I get an error saying neither are unique and so that doesn't work for me.

Anyone any ideas what could be causing this? Thanks

=======================================================================================

A:

About the first error you get ("command failed: No such device (-19)"): You can either use

iw phy phy0 interface add <name> type <type>

or

iw dev wlan0 interface add <name> type <type>

As long as the physical names and the device names don't clash, you can also omit the phy/dev keywords and simply use

iw phy0 interface add <name> type <type>

---

About using both interfaces at the same time and the message about them not being unique:
This is probably because they both use the same MAC address. You can try to change the MAC address of the new interface before activating it.

ip link set dev <dev-name> address <new-mac-address>

---

A word about your interface modes:
My iw command (v3.4) says

Valid interface types are: managed, ibss, monitor, mesh, wds.

Not sure what "station" will do.

Also, if you're trying to operate the two interfaces in different modes, make sure your wlan card supports this:

iw list[...]Supported interface modes:     * IBSS     * managed     * AP     * AP/VLAN     * WDS     * monitor     * mesh pointsoftware interface modes (can always be added):     * AP/VLAN     * monitorinterface combinations are not supported

Notice the last line.

=======================================================================================

A:

iw dev <devname> interface add wlan1 type station

phy0 here in iw dev phy0 interface add wlan1 type station is a phyname, so you need change it towlan0