CDS WAP 测试错误代码含义
来源:互联网 发布:网络整合营销推广 编辑:程序博客网 时间:2024/06/15 04:46
WAP 测试错误代码含义
状态代码在0x10以下是WTP层协议发生错误,错误代码含义如下
Table 19 WTP Provider Abort Codes
Abort reason (PROVIDER)
code
Description
Unknown (UNKNOWN)
0X00
A generic error code indicating an unexpected error
Protocol Error (PROTOERR)
0X01
The received PDU could not be interpreted. The structure MAY be wrong.
Invalid TID (INVALIDTID)
0X02
Only used by the initiator as a negative result to the TID verification.
Not Implemented Class 2 (NOTIMPLEMENTEDCL2)
0X03
The transaction could not be completed since the Responder does not support Class 2 transactions.
Not Implemented SAR (NOTIMPLEMENTEDSAR)
0X04
The transaction could not be completed since the Responder does not support SAR.
Not Implemented User Acknowledgement (NOTIMPLEMENTEDUACK)
0X05
The transaction could not be completed since the Responder does not support User Acknowledgements.
WTP Version One (WTPVERSIONONE)
0X06
Current version is 1.The initiator requested a different version that is not supported.
Capacity Temporarily Exceeded (CAPTEMPEXCEEDED)
0X07
Due to an overload situation the transaction can not be completed.
No Response (NORESPONSE)
0X08
A User acknowledgement was requested but the WTP user did not respond.
Message too large (MESSAGETOOLARGE)
0X09
Due to a message size bigger than capabilities of the receiver the transaction cannot be completed.
Not Implemented Extended SAR (NOTIMPLEMENTEDESAR)
0X0A
The transaction could not be completed since the Responder does not support extended SAR.
状态代码在0xE0以上是WSP层协议发生错误,错误代码含义如下:
Table 35. Abort Reason Code Assignments
Name
Assigned Number
Description
PROTOERR
0xE0
Protocol error, illegal PDU received
DISCONNECT
0xE1
Session has been disconnected
SUSPEND
0xE2
Session has been suspended
RESUME
0xE3
Session has been resumed
CONGESTION
0xE4
The peer is congested and can not process the SDU
CONNECTERR
0xE5
The session con not failed
MRUEXCEEDED
0xE6
The Maximum Receive Unit size was exceeded
MOREXCEEDED
0xE7
The Maximum Outstanding Requests was exceeded
PEERREQ
0xE8
Peer request
NETERR
0xE9
Network error
USERREQ
0xEA
User request
USERRFS
0xEB
User refused Push message. No specific cause, no retries
USERPND
0xEC
Push message cannot be delivered to intended destination
USERDCR
0xED
Push message discarded due to resource shortage
USERDCU
0xEE
Content type of Push message cannot be processed
状态代码在0x10至0x65之间与Http协议的返回码具有对应关系,下表中第一列为Http的状态码,第二列为其含义(参见RFC2608),第三列为WSP中的状态码
100
0x10
Continue
101
0x11
Switching Protocols
200
0x20
OK, Success
201
0x21
Created
202
0x22
Accepted
203
0x23
Non-Authoritative Information
204
0x24
No Content
205
0x25
Reset Content
206
0x26
Partial Content
300
ox30
Multiple Choices
301
ox31
Moved Permanently
302
ox32
Moved temporarily
303
ox33
See Other
304
ox34
Not modified
305
ox35
Use Proxy
306
ox36
(reserved)
307
ox37
Temporary Redirect
400
0x40
Bad Request - server could not understand request
401
0x41
Unauthorized
402
0x42
Payment required
403
0x43
Forbidden - operation is understood but refused
404
0x44
Not Found
405
0x45
Method not allowed
406
0x46
Not Acceptable
407
0x47
Proxy Authentication required
408
0x48
Reset Timeout
409
0x49
Conflict
410
0x4A
Gone
411
0x4B
Length Required
412
0x4C
Precondition failed
413
0x4D
Request entity too large
414
0x4E
Request -URI too large
415
0x4F
Unsupported media type
416
0x50
Requested Range Not Satisfiable
417
0x51
Expectation Failed
500
0x60
Internal Server
501
0x61
Not Implemented
502
0x62
Bad Gateway
503
0x63
Service Unavailable
504
0x64
Gateway Timeout
505
0x65
HTTP version not supported
HTTP状态代码 状态信息 含义
100 Continue 初始的请求已经接受,客户应当继续发送请求的其余部分。(HTTP 1.1新)
101 Switching Protocols 服务器将遵从客户的请求转换到另外一种协议(HTTP 1.1新)
200 OK 一切正常,对GET和POST请求的应答文档跟在后面。
201 Created 服务器已经创建了文档,Location头给出了它的URL。
202 Accepted 已经接受请求,但处理尚未完成。
203 Non-Authoritative Information 文档已经正常地返回,但一些应答头可能不正确,因为使用的是文档的拷贝(HTTP 1.1新)。
204 No Content 没有新文档,浏览器应该继续显示原来的文档。如果用户定期地刷新页面,而Servlet可以确定用户文档足够新,这个状态代码是很有用的。
205 Reset Content 没有新的内容,但浏览器应该重置它所显示的内容。用来强制浏览器清除表单输入内容(HTTP 1.1新)。
206 Partial Content 客户发送了一个带有Range头的GET请求,服务器完成了它(HTTP 1.1新)。
300 Multiple Choices 客户请求的文档可以在多个位置找到,这些位置已经在返回的文档内列出。如果服务器要提出优先选择,则应该在Location应答头指明。
301 Moved Permanently 客户请求的文档在其他地方,新的URL在Location头中给出,浏览器应该自动地访问新的URL。
302 Found 类似于301,但新的URL应该被视为临时性的替代,而不是永久性的。注意,在HTTP1.0中对应的状态信息是“Moved Temporatily”。
出现该状态代码时,浏览器能够自动访问新的URL,因此它是一个很有用的状态代码。
注意这个状态代码有时候可以和301替换使用。例如,如果浏览器错误地请求(缺少了后面的斜杠),有的服务器返回301,有的则返回302。
严格地说,我们只能假定只有当原来的请求是GET时浏览器才会自动重定向。请参见307。
303 See Other 类似于301/302,不同之处在于,如果原来的请求是POST,Location头指定的重定向目标文档应该通过GET提取(HTTP 1.1新)。
304 Not Modified 客户端有缓冲的文档并发出了一个条件性的请求(一般是提供If-Modified-Since头表示客户只想比指定日期更新的文档)。服务器告诉客户,原来缓冲的文档还可以继续使用。
305 Use Proxy 客户请求的文档应该通过Location头所指明的代理服务器提取(HTTP 1.1新)。
307 Temporary Redirect 和302(Found)相同。许多浏览器会错误地响应302应答进行重定向,即使原来的请求是POST,即使它实际上只能在POST请求的应答是303时才能重定向。由于这个原因,HTTP 1.1新增了307,以便更加清除地区分几个状态代码:当出现303应答时,浏览器可以跟随重定向的GET和POST请求;如果是307应答,则浏览器只能跟随对GET请求的重定向。(HTTP 1.1新)
400 Bad Request 请求出现语法错误。
401 Unauthorized 客户试图未经授权访问受密码保护的页面。应答中会包含一个WWW-Authenticate头,浏览器据此显示用户名字/密码对话框,然后在填写合适的Authorization头后再次发出请求。
403 Forbidden 资源不可用。服务器理解客户的请求,但拒绝处理它。通常由于服务器上文件或目录的权限设置导致。
404 Not Found 无法找到指定位置的资源。这也是一个常用的应答。
405 Method Not Allowed 请求方法(GET、POST、HEAD、DELETE、PUT、TRACE等)对指定的资源不适用。(HTTP 1.1新)
406 Not Acceptable 指定的资源已经找到,但它的MIME类型和客户在Accpet头中所指定的不兼容(HTTP 1.1新)。
407 Proxy Authentication Required 类似于401,表示客户必须先经过代理服务器的授权。(HTTP 1.1新)
408 Request Timeout 在服务器许可的等待时间内,客户一直没有发出任何请求。客户可以在以后重复同一请求。(HTTP 1.1新)
409 Conflict 通常和PUT请求有关。由于请求和资源的当前状态相冲突,因此请求不能成功。(HTTP1.1新)
410 Gone 所请求的文档已经不再可用,而且服务器不知道应该重定向到哪一个地址。它和404的不同在于,返回407表示文档永久地离开了指定的位置,而404表示由于未知的原因文档不可用。(HTTP 1.1新)
411 Length Required 服务器不能处理请求,除非客户发送一个Content-Length头。(HTTP 1.1新)
412 Precondition Failed 请求头中指定的一些前提条件失败(HTTP 1.1新)。
413 Request Entity Too Large 目标文档的大小超过服务器当前愿意处理的大?gt;>H绻 衿魅衔 约耗芄簧院笤俅 砀们肭螅 蛴Ω锰峁┮桓鯮etry-After头(HTTP 1.1新)。
414 Request URI Too Long URI太长(HTTP 1.1新)。
416 Requested Range Not Satisfiable 服务器不能满足客户在请求中指定的Range头。(HTTP 1.1新)
500 Internal Server Error 服务器遇到了意料不到的情况,不能完成客户的请求。
501 Not Implemented 服务器不支持实现请求所需要的功能。例如,客户发出了一个服务器不支持的PUT请求。
502 Bad Gateway 服务器作为网关或者代理时,为了完成请求访问下一个服务器,但该服务器返回了非法的应答。
503 Service Unavailable 服务器由于维护或者负载过重未能应答。例如,Servlet可能在数据库连接池已满的情况下返回503。服务器返回503时可以提供一个Retry-After头。
504 Gateway Timeout 由作为代理或网关的服务器使用,表示不能及时地从远程服务器获得应答。(HTTP 1.1新)
505 HTTP Version Not Supported 服务器不支持
- CDS WAP 测试错误代码含义
- CDS
- cds
- 测试错误代码
- http错误代码含义
- http错误代码含义
- http错误代码含义
- 蓝屏错误代码含义
- 调用GetLastError 错误代码 含义
- HTTP 错误代码含义
- http错误代码含义
- http错误代码含义
- http错误代码含义大全
- CURL错误代码及含义
- http错误代码含义:
- HTTP错误代码及其含义
- Http错误代码含义
- http错误代码含义
- 配置文件
- jquery中validate使用
- (转)java权限管理与用户角色权限设计
- lucene 分词器Analyzer
- char,string,CString相互转换
- CDS WAP 测试错误代码含义
- android Intent学习总结
- Android--为TextView添加边框
- Ubuntu 10.04 64bit Android4.0 编译服务器配置
- 一个朴素的24点算法
- ubuntu12.04下安装与配置eclipse
- 如何判断出连接到电脑的USB设备是手机?
- php复习题1
- JavaWEB开发-国际化