VMware安装Gentoo及注意事项

大体上按照官网的Handbook（英文版）安装即可，有以下几点注意下：

（1）如果使用的virtual disk type时使用的是默认的SCSI时，需要在编译内核的时候把下面这些模块支持添加进去（直接编译进内核[*]）

-->Device Drivers-->SCSI device support--><*>SCSI disk support-->Device Drivers-->SCSI device support-->SCSI low-level drivers-->             <*>BusLogic SCI support-->FlashPoint support        -->Device Drivers-->Fusion MPT device support-->所有的        -->Device Drivers-->USB support--><*>USB Mass Storage support        -->Device Drivers-->Networking support-->Ethernet driver support(NEW)-->             <*>AMD PCnet32 PCI support------------------------------------------------------------------------------------------------------->Device Drivers --->  SCSI device support  --->    <*> SCSI device support    <*> SCSI disk support        SCSI low-level drivers  --->           <*> SYM53C8XX Version 2 SCSI support-----------------------------------------------------------------------------------------------------Device Drivers --->  SCSI device support  --->    <*> SCSI device support    <*>   SCSI disk support          SCSI low-level drivers  --->             <*> BusLogic SCSI support------------------------------------------------------------------------------------------------------->Bus options (PCI etc.) --->   [*] PCI Support  [*] ISA Support

（2）本地化中文支持：

# nano -w /etc/locale.gen

添加以下几行

en_US  ISO-8859-1en_US.UTF-8  UTF-8zh_CN  GB18030zh_CN.GBK  GBKzh_CN.GB2312  GB2312zh_CN.UTF-8  UTF-8

        # nano -w /etc/02locale

        添加以下几行

LANG="en_US.UTF-8"LC_CTYPE="zh_CN.UTF-8"LC_NUMERIC="en_US.UTF-8"LC_TIME="en_US.UTF-8"LC_COLLATE="en_US.UTF-8"LC_MONETARY="en_US.UTF-8"LC_MESSAGES="en_US.UTF-8"LC_PAPER="en_US.UTF-8"LC_NAME="en_US.UTF-8"LC_ADDRESS="en_US.UTF-8"LC_TELEPHONE="en_US.UTF-8"LC_MEASUREMENT="en_US.UTF-8"LC_IDENTIFICATION="en_US.UTF-8"

（3）安装完成重启后ifonfig没有eth0 ？

这边的情况是网络接口名称改变了，eth0 -> enp2s1 （/etc/init.d/dhcpcd start  之后再ifconfig就看得到了）

        1. 删除原有连接 # rm /etc/init.d/net.eth0

      2. 重建连接# ln -s net.lo net.enp2s1

3. 重新配置网口名# nano -w /etc/conf.d/net config_eth0="dhcp"      -> config_enp2s1="dhcp"

4. reboot一下看看，如果之前有设置dhcpcd自动启动的话，ifconfig就看得到了

Enjoy your Gentoo !

reference: 

http://www.gentoo.org/doc/en/handbook/handbook-x86.xml

http://www.wutianqi.com/

http://huagelinux.blog.163.com/blog/static/87337083201002201211946/