Lecroy 813Zi-A User Note For USB 3.0

Device Scope PeRT3 (Host TX and RX Tests)
This configuration is meant to run all of the transmitter and receiver tests for a user that has a PeRT3 but not the RF Switch. All of the variables are set to default except Product Type is set to “Device”, Use PeRT3 is set to “Yes” and Channel File is set to “Host11inWith3mCable.s4p.” The limit set used is ComplianceLimits. The tests that are run are:
 Test 1.1 – Low Frequency Periodic Signaling
 Test 1.2 – Spread Spectrum Tests
 Test 1.3 – Jitter & Eye Diagram Tests
o Test 1.3.1 – Jitter
o Test 1.3.2 – Phase Jitter Slew Rate
o Test 1.3.3 – SigTest Jitter
o Test 1.3.4 – Eye Diagram
o Test 1.3.5 – SigTest Eye Diagram
 Test 1.4 – AC & DC Common Mode Test
 Test 1.5 – Differential Voltage & De-emphasis Test

 Test 2.1. – Jitter Tolerance Test

hahaha