U-Boot 1.1.6 (Nov 30 2013 - 21:31:17) for SMDK6410****************************************** u-boot 1.1.6 **** Updated for TE6410 Board **** Version 1.0 (10-01-15) **** OEM: Forlinx Embedded **** Web: http://www.witech.com.cn ******************************************CPU: S3C6410 @532MHz Fclk = 532MHz, Hclk = 133MHz, Pclk = 66MHz, Serial = CLKUART (SYNC Mode) Board: SMDK6410DRAM: 256 MBFlash: 0 kBNAND: select s3c_nand_oob_mlc_1282048 MB *** Warning - bad CRC or NAND, using default environmentIn: serialOut: serialErr: serialHit any key to stop autoboot: 0 NAND read: device 0 offset 0x100000, size 0x300000s3c-nand: 1 bit(s) error detected, corrected successfully 3145728 bytes read: OKBoot with zImageStarting kernel ...Uncompressing Linux... done, booting the kernel.Booting Linux on physical CPU 0x0Linux version 3.11.6-ged9c322-dirty (clare@clare-K43E) (gcc version 4.2.2) #17 Sun Dec 1 12:08:23 CST 2013CPU: ARMv6-compatible processor [410fb766] revision 6 (ARMv7), cr=00c5387dCPU: PIPT / VIPT nonaliasing data cache, VIPT nonaliasing instruction cacheMachine: SMDK6410Memory policy: ECC disabled, Data cache writebackCPU S3C6410 (id 0x36410101)S3C24XX Clocks, Copyright 2004 Simtec ElectronicsS3C64XX: PLL settings, A=532000000, M=532000000, E=24000000S3C64XX: HCLK2=266000000, HCLK=133000000, PCLK=66500000mout_apll: source is fout_apll (1), rate is 532000000mout_epll: source is epll (1), rate is 24000000mout_mpll: source is mpll (1), rate is 532000000usb-bus-host: source is clk_48m (0), rate is 48000000irda-bus: source is mout_epll (0), rate is 24000000CPU: found DTCM0 8k @ 00000000, not enabledCPU: moved DTCM0 8k to fffe8000, enabledCPU: found DTCM1 8k @ 00000000, not enabledCPU: moved DTCM1 8k to fffea000, enabledCPU: found ITCM0 8k @ 00000000, not enabledCPU: moved ITCM0 8k to fffe0000, enabledCPU: found ITCM1 8k @ 00000000, not enabledCPU: moved ITCM1 8k to fffe2000, enabledBuilt 1 zonelists in Zone order, mobility grouping on. Total pages: 65024Kernel command line: root=/dev/mtdblock2 rootfstype=cramfs console=ttySAC0,115200PID hash table entries: 1024 (order: 0, 4096 bytes)Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)Memory: 256196K/262144K available (2331K kernel code, 225K rwdata, 704K rodata, 125K init, 202K bss, 5948K reserved)Virtual kernel memory layout: vector : 0xffff0000 - 0xffff1000 ( 4 kB) DTCM : 0xfffe8000 - 0xfffec000 ( 16 kB) ITCM : 0xfffe0000 - 0xfffe4000 ( 16 kB) fixmap : 0xfff00000 - 0xfffe0000 ( 896 kB) vmalloc : 0xd0800000 - 0xff000000 ( 744 MB) lowmem : 0xc0000000 - 0xd0000000 ( 256 MB) modules : 0xbf000000 - 0xc0000000 ( 16 MB) .text : 0xc0008000 - 0xc02ff124 (3037 kB) .init : 0xc0300000 - 0xc031f45c ( 126 kB) .data : 0xc0320000 - 0xc03587c0 ( 226 kB) .bss : 0xc0359000 - 0xc038b868 ( 203 kB)SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1NR_IRQS:390VIC @f6000000: id 0x00041192, vendor 0x41VIC @f6010000: id 0x00041192, vendor 0x41sched_clock: 32 bits at 33MHz, resolution 30ns, wraps every 129171msConsole: colour dummy device 80x30Calibrating delay loop... 353.89 BogoMIPS (lpj=1769472)pid_max: default: 32768 minimum: 301Mount-cache hash table entries: 512CPU: Testing write buffer coherency: okSetting up static identity map for 0xc0234c38 - 0xc0234c94NET: Registered protocol family 16DMA: preallocated 256 KiB pool for atomic coherent allocationss3c64xx_dma_init: Registering DMA channelsPL080: IRQ 73, at d0846000, channels 0..8PL080: IRQ 74, at d0848000, channels 8..16S3C6410: Initialising architecturebio: create slab <bio-0> at 0usbcore: registered new interface driver usbfsusbcore: registered new interface driver hubusbcore: registered new device driver usbs3c-i2c s3c2440-i2c.0: slave address 0x10s3c-i2c s3c2440-i2c.0: bus frequency set to 64 KHzs3c-i2c s3c2440-i2c.0: i2c-0: S3C I2C adapters3c-i2c s3c2440-i2c.1: slave address 0x10s3c-i2c s3c2440-i2c.1: bus frequency set to 64 KHzs3c-i2c s3c2440-i2c.1: i2c-1: S3C I2C adapterSwitched to clocksource samsung_clocksource_timerROMFS MTD (C) 2007 Red Hat, Inc.io scheduler noop registeredio scheduler deadline registeredio scheduler cfq registered (default)s3c-fb s3c-fb: window 0: fb Serial: 8250/16550 driver, 4 ports, IRQ sharing disableds3c6400-uart.0: ttySAC0 at MMIO 0x7f005000 (irq = 69) is a S3C6400/10console [ttySAC0] enableds3c6400-uart.1: ttySAC1 at MMIO 0x7f005400 (irq = 70) is a S3C6400/10s3c6400-uart.2: ttySAC2 at MMIO 0x7f005800 (irq = 71) is a S3C6400/10s3c6400-uart.3: ttySAC3 at MMIO 0x7f005c00 (irq = 72) is a S3C6400/10brd: module loadedloop: module loadedat24 0-0050: 1024 byte 24c08 EEPROM, writable, 1 bytes/writeat24 1-0057: 16384 byte 24c128 EEPROM, writable, 1 bytes/writenand-s3c2410: -1070404632 ns is too big for current clock rate 133000s3c24xx-nand s3c6400-nand: cannot get suitable timingss3c24xx-nand: probe of s3c6400-nand failed with error -22S3C NAND Driver, (c) 2008 Samsung ElectronicsS3C NAND Driver is using software ECC.NAND device: Manufacturer ID: 0xec, Chip ID: 0xd5 (Samsung NAND 2GiB 3,3V 8-bit), 2048MiB, page size: 4096, OOB size:8Creating 4 MTD partitions on "NAND 2GiB 3,3V 8-bit":0x000000000000-0x000000040000 : "Bootloader"0x000000040000-0x000000400000 : "Kernel"0x000000400000-0x000005400000 : "Rootfs"0x000005400000-0x000080000000 : "File System"ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Drivers3c2410-ohci s3c2410-ohci: S3C24XX OHCIs3c2410-ohci s3c2410-ohci: new USB bus registered, assigned bus number 1s3c2410-ohci s3c2410-ohci: irq 79, io mem 0x74300000s3c2410-ohci s3c2410-ohci: init err (00000000 0000)s3c2410-ohci s3c2410-ohci: can't start s3c24xxs3c2410-ohci s3c2410-ohci: startup error -75s3c2410-ohci s3c2410-ohci: USB bus 1 deregistereds3c2410-ohci: probe of s3c2410-ohci failed with error -75mousedev: PS/2 mouse device common for all mices3c-rtc s3c64xx-rtc: rtc disabled, re-enablings3c-rtc s3c64xx-rtc: rtc core: registered s3c as rtc0i2c /dev entries driversdhci: Secure Digital Host Controller Interface driversdhci: Copyright(c) Pierre Ossmans3c-sdhci s3c-sdhci.0: clock source 0: mmc_busclk.0 (133000000 Hz)s3c-sdhci s3c-sdhci.0: clock source 2: mmc_busclk.2 (24000000 Hz)mmc0: SDHCI controller on samsung-hsmmc [s3c-sdhci.0] using ADMAmmc0: mmc_rescan_try_freq: trying to init card at 400000 Hzusbcore: registered new interface driver usbhidusbhid: USB HID core driverVFP support v0.3: implementor 41 architecture 1 part 20 variant b rev 5s3c-rtc s3c64xx-rtc: setting system clock to 2000-01-01 14:00:31 UTC (946735231)__nand_correct_data: uncorrectable ECC error__nand_correct_data: uncorrectable ECC errorend_request: I/O error, dev mtdblock2, sector 0Buffer I/O error on device mtdblock2, logical block 0__nand_correct_data: uncorrectable ECC error__nand_correct_data: uncorrectable ECC errorend_request: I/O error, dev mtdblock2, sector 0Buffer I/O error on device mtdblock2, logical block 0__nand_correct_data: uncorrectable ECC error__nand_correct_data: uncorrectable ECC errorend_request: I/O error, dev mtdblock2, sector 8Buffer I/O error on device mtdblock2, logical block 1__nand_correct_data: uncorrectable ECC error__nand_correct_data: uncorrectable ECC errorend_request: I/O error, dev mtdblock2, sector 8Buffer I/O error on device mtdblock2, logical block 1__nand_correct_data: uncorrectable ECC error__nand_correct_data: uncorrectable ECC errorend_request: I/O error, dev mtdblock2, sector 16Buffer I/O error on device mtdblock2, logical block 2__nand_correct_data: uncorrectable ECC error__nand_correct_data: uncorrectable ECC errorend_request: I/O error, dev mtdblock2, sector 16Buffer I/O error on device mtdblock2, logical block 2__nand_correct_data: uncorrectable ECC error__nand_correct_data: uncorrectable ECC errorend_request: I/O error, dev mtdblock2, sector 24Buffer I/O error on device mtdblock2, logical block 3__nand_correct_data: uncorrectable ECC error__nand_correct_data: uncorrectable ECC errorend_request: I/O error, dev mtdblock2, sector 24Buffer I/O error on device mtdblock2, logical block 3List of all partitions:1f00 256 mtdblock0 (driver?)1f01 3840 mtdblock1 (driver?)1f02 81920 mtdblock2 (driver?)1f03 2011136 mtdblock3 (driver?)No filesystem could mount root, tried: cramfsKernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(31,2)CPU: 0 PID: 1 Comm: swapper Not tainted 3.11.6-ged9c322-dirty #17[<c0014138>] (unwind_backtrace+0x0/0xf8) from [<c00119c4>] (show_stack+0x14/0x1c)[<c00119c4>] (show_stack+0x14/0x1c) from [<c001e6e8>] (panic+0x90/0x220)[<c001e6e8>] (panic+0x90/0x220) from [<c0301010>] (mount_block_root+0x1c8/0x2ec)[<c0301010>] (mount_block_root+0x1c8/0x2ec) from [<c03012ec>] (prepare_namespace+0x14c/0x1dc)[<c03012ec>] (prepare_namespace+0x14c/0x1dc) from [<c03008cc>] (kernel_init_freeable+0x168/0x1c4)[<c03008cc>] (kernel_init_freeable+0x168/0x1c4) from [<c0230d24>] (kernel_init+0x8/0xe8)[<c0230d24>] (kernel_init+0x8/0xe8) from [<c000e558>] (ret_from_fork+0x14/0x3c)
