USB Device Descriptor for AMP Controller

来源：互联网发布：家庭网络组建方案编辑：程序博客网时间：2024/05/14 13:37

The values shown in the following tables shall be used in the Device Descriptor for Bluetooth controller devices with USB HCI transport.

These values shouldalso be used in the interface descriptors for the interfaces described inSection 2.1 and as described in the following sections.

Composite Bluetooth Primary and AMP Controller

Set the Class,Subclass, and Protocol values for the Device Descriptor as defined in the USBInterface Association Descriptor (IAD) ECN. Set the Class, Subclass, and Protocol values for each Interface Descriptor which applies to the Primary Controller as defined in Table 3.1.

Set the Class,Subclass, and Protocol values for the each Interface Descriptor which appliesto the AMP Controller as defined in Table 3.2.

Composite Device Including Bluetooth Primary and AMP Controller

Set the Class,Subclass, and Protocol values for the Device Descriptor to as defined in Table3.3.

Set the Class,Subclass, and Protocol values for each Interface Descriptor which applies tothe Primary Controller as defined in Table 3.1.

Set the Class,Subclass, and Protocol values for the each Interface Descriptor which applies to the AMP Controller as defined in Table 3.2.

0 0