adb如何通过wifi连接手机

From：http://developer.android.com/tools/help/adb.html

adb is usually used over USB. However, it is also possible to use over Wi-Fi, as described here.

1. Connect Android device and adb host computer to a common Wi-Fi network accessible to both. We have found that not all access points are suitable; you may need to use an access point whose firewall is configured properly to support adb. 译：手机需与PC连接到同一个无线热点。
2. Connect the device with USB cable to host.
3. Make sure adb is running in USB mode on host. 译：通过USB连接手机

   $ adb usbrestarting in USB mode

4. Connect to the device over USB.译：执行以下命令查看adb连接列表。注：执行第三步命令后，可能会一直停在那里，需新开cmd窗口执行下述命令

   $ adb devicesList of devices attached######## device

5. Restart host adb in tcpip mode.译：设置为tcpip模式

   $ adb tcpip 5555restarting in TCP mode port: 5555

6. Find out the IP address of the Android device: Settings -> About tablet -> Status -> IP address. Remember the IP address, of the form #.#.#.#. 译：查看当前手机获取ip：设置->关于手机->状态消息->ip地址
7. Connect adb host to device: 译：在cmd命令行下，通过adb connect ip地址 命令连接到手机

   $ adb connect #.#.#.#connected to #.#.#.#:5555

8. Remove USB cable from device, and confirm you can still access device:译：拔出USB线，并查看adb连接列表确认是通过ip连接

   $ adb devicesList of devices attached#.#.#.#:5555 device

You're now good to go!

If the adb connection is ever lost:

1. Make sure that your host is still connected to the same Wi-Fi network your Android device is.
2. Reconnect by executing the "adb connect" step again. 译：如果出现中断可以重新执行第7步的connect命令
3. Or if that doesn't work, reset your adb host: 译： 或者杀死adb server进程后重新执行上述命令。

   adb kill-server

   and then start over from the beginning.