POJ 1887 Testing the CATCHER(LIS的反面 最大递减子序列)
来源:互联网 发布:seo工作职责 编辑:程序博客网 时间:2024/05/22 10:53
Language:
Testing the CATCHER
Time Limit: 1000MS Memory Limit: 30000KTotal Submissions: 15207 Accepted: 5595
Description
A military contractor for the Department of Defense has just completed a series of preliminary tests for a new defensive missile called the CATCHER which is capable of intercepting multiple incoming offensive missiles. The CATCHER is supposed to be a remarkable defensive missile. It can move forward, laterally, and downward at very fast speeds, and it can intercept an offensive missile without being damaged. But it does have one major flaw. Although it can be fired to reach any initial elevation, it has no power to move higher than the last missile that it has intercepted.
The tests which the contractor completed were computer simulations of battlefield and hostile attack conditions. Since they were only preliminary, the simulations tested only the CATCHER's vertical movement capability. In each simulation, the CATCHER was fired at a sequence of offensive missiles which were incoming at fixed time intervals. The only information available to the CATCHER for each incoming missile was its height at the point it could be intercepted and where it appeared in the sequence of missiles. Each incoming missile for a test run is represented in the sequence only once.
The result of each test is reported as the sequence of incoming missiles and the total number of those missiles that are intercepted by the CATCHER in that test.
The General Accounting Office wants to be sure that the simulation test results submitted by the military contractor are attainable, given the constraints of the CATCHER. You must write a program that takes input data representing the pattern of incoming missiles for several different tests and outputs the maximum numbers of missiles that the CATCHER can intercept for those tests. For any incoming missile in a test, the CATCHER is able to intercept it if and only if it satisfies one of these two conditions:
The incoming missile is the first missile to be intercepted in this test.
-or-
The missile was fired after the last missile that was intercepted and it is not higher than the last missile which was intercepted.
The tests which the contractor completed were computer simulations of battlefield and hostile attack conditions. Since they were only preliminary, the simulations tested only the CATCHER's vertical movement capability. In each simulation, the CATCHER was fired at a sequence of offensive missiles which were incoming at fixed time intervals. The only information available to the CATCHER for each incoming missile was its height at the point it could be intercepted and where it appeared in the sequence of missiles. Each incoming missile for a test run is represented in the sequence only once.
The result of each test is reported as the sequence of incoming missiles and the total number of those missiles that are intercepted by the CATCHER in that test.
The General Accounting Office wants to be sure that the simulation test results submitted by the military contractor are attainable, given the constraints of the CATCHER. You must write a program that takes input data representing the pattern of incoming missiles for several different tests and outputs the maximum numbers of missiles that the CATCHER can intercept for those tests. For any incoming missile in a test, the CATCHER is able to intercept it if and only if it satisfies one of these two conditions:
The incoming missile is the first missile to be intercepted in this test.
-or-
The missile was fired after the last missile that was intercepted and it is not higher than the last missile which was intercepted.
Input
The input data for any test consists of a sequence of one or more non-negative integers, all of which are less than or equal to 32,767, representing the heights of the incoming missiles (the test pattern). The last number in each sequence is -1, which signifies the end of data for that particular test and is not considered to represent a missile height. The end of data for the entire input is the number -1 as the first value in a test; it is not considered to be a separate test.
Output
Output for each test consists of a test number (Test #1, Test #2, etc.) and the maximum number of incoming missiles that the CATCHER could possibly intercept for the test. That maximum number appears after an identifying message. There must be at least one blank line between output for successive data sets.
Note: The number of missiles for any given test is not limited. If your solution is based on an inefficient algorithm, it may not execute in the allotted time.
Note: The number of missiles for any given test is not limited. If your solution is based on an inefficient algorithm, it may not execute in the allotted time.
Sample Input
38920715530029917015865-1233421-1-1
Sample Output
Test #1: maximum possible interceptions: 6Test #2: maximum possible interceptions: 2
Source
World Finals 1994
#include<iostream>#include<cstdio>#include<cstring>#include<algorithm>#include<cmath>#include<queue>#include<stack>#include<vector>#define L(x) (x<<1)#define R(x) (x<<1|1)#define MID(x,y) ((x+y)>>1)#define eps 1e-8using namespace std;#define N 10005int a[N],dp[N];int main(){int i,j,n,x,ca=0;while(scanf("%d",&x)){if(x==-1) break;n=0;a[n++]=x;while(1){scanf("%d",&x);if(x==-1) break;a[n++]=x;}dp[0]=1;int ans=1;int temp;for(i=1;i<n;i++){temp=0;for(j=0;j<i;j++)if(a[j]>a[i]&&temp<dp[j])temp=dp[j];dp[i]=temp+1;if(ans<dp[i])ans=dp[i];} printf("Test #%d:\n",++ca); printf(" maximum possible interceptions: %d\n\n",ans);} return 0;}
0 0
- POJ 1887 Testing the CATCHER(LIS的反面 最大递减子序列)
- POJ 1887 Testing the CATCHER(最长递减子序列)
- Testing the CATCHER - POJ 1887 最长递减子序列
- POJ 1887:Testing the CATCHER 求递减序列的最大值
- POJ 1887 Testing the CATCHER(LIS)
- POJ-1887-Testing the CATCHER-最长递减子序列-DP动态规划
- poj 1887Testing the CATCHER(最长下降子序列)
- POJ 1887 Testing the CATCHER(最长下降子序列)
- Poj 1887 Testing the CATCHER(LIS)
- Testing the CATCHER Uva231 最长递减子序列
- poj 1887 Testing the CATCHER(动态规划:LIS)
- poj-1887Testing the CATCHER(LIS变形)
- poj 1887 Testing the CATCHER(最长递增子序列)
- POJ 1887-Testing the CATCHER(dp_最长下降子序列)
- 【POJ1887 || 2355 || 1631】Testing the CATCHER(最长递增(递减)子序列)NYOJ224
- 最长单调递减子序列(非严格单调) uva 231Testing the CATCHER
- poj 1887 Testing the CATCHER (最长不上升子序列)
- POJ-1887 Testing the CATCHER(dp,最长下降子序列)
- R语言 读取图像
- Android USB Host 使用详解(U盘)(一)
- WSAEventSelect模型编程
- hdu 1047 Integer Inquiry(大整数求和)
- 超强JSP防SQL注入攻击
- POJ 1887 Testing the CATCHER(LIS的反面 最大递减子序列)
- 编译hadoop2.2.0的eclipse插件流程总结
- VC下获取系统时间
- ORACLE 游标遍历
- 【HDU】病毒侵袭(AC自动机模板题)
- 分享8年开发经验,浅谈程序员职业规划
- C基础 - 常量与变量(2)
- 第8周项目2加班费
- 第六章 6.2.3节练习