6410开发板通过USB烧写u-boot，kernel，system

来源：互联网发布：电影配乐知乎编辑：程序博客网时间：2024/06/05 14:12

上电后，在串口按任意键进入菜单

Hit any key to stop autoboot: 0

###################### User Menu for OK6410#####################
[1] Format the nand flash
[2] Burn image from USB
[3] configure the lcd size
[4] Boot the system
[5] Reboot the u-boot
[6] Exit to command line
-----------------------------Select---------------------------------
Enter your Selection:

按照提示选择2，通过USB烧写

Enter your Selection:2

##### Select the fuction #####
[1] Flash u-boot
[2] Flash kernel
[3] Flash system
[4] Exit

出现烧写菜单，选择3烧写文件系统

Enter your Selection:3

NAND erase: device 0 offset 0x1e00000, size 0x3e200000
Erasing at 0x3ff80000 -- 100% complete.Erasing at 0x3ce00000 -- 95% complete.
OK
OTG cable Connected!
Now, Waiting for DNW to transmit data

这个时候在dnw的菜单里USB Port -> Transmit选择文件

Download Done!! Download Address: 0x50008000, Download Filesize:0x7f5c000
Checksum is being calculated...................................®....®.......®...................®.........®.........®....Checksum O.K................®......Š

NAND write: device 0 offset 0x1e00000, size 0x7f5c000

Writing data at 0x8aae000 -- 88% complete.Writing data at 0x8bea000 -- 89% complete.Writing data at 0x8d26000 -- 90%Writing data at 0x997f000 -- 100% complete.Writing data at 0x8f9e000 -- 92% complete.
133545984 bytes written: OK

之前有在dnw软件Configuration -> Options把下载地址改成了0x50008000

提示写入完成后，断电重启

0 0