Build up pppoe server on Win 2K/XP

来源：互联网发布：炉石盒子mac版怎么用编辑：程序博客网时间：2024/05/20 06:54

Howto build up pppoe server on Win 2K/XP

nat32p http://members.driverguide.com/driver/detail.php?driverid=107890

RASPPPOE_098 You can search this software on internet.... :)

install steps:

1. unzip these 2 zip files
2. copy "/nat32p" (unzip folder) to c:/program files/
3. open property of My network place
4. open property of Local Area Connection
5. click on "install", choose "protocol", click "Add", click "have disk"
6. browser to "/RASPPPOE_098" (unzip folder)
7. choose "OEMSETNT", press "OK", (skip some steps here)
8. open property of My network place
9. double click on "New Connection Wizard" , and "Next"
10. choose "Set up an advanced connection", and "Next"
11. choose "Accept incoming connection",
12. choose the interface and "Next"
13. choose allow virtual private connection
14. setup your user account, and "Next"
15. choose "Internet Protocol(TCP/IP)", and click on "Properties"
16. specify your IP address range and choose "allow calling computer to specify its own IP address"
17. finish
18. reboot your PC

Then you can use EnterNet 500 under Win 2K or use the private dial software under Win XP to test this pppoe server by pre-setting username and password. Good Luck!

I usually use this PPPoE server to test our ADSL sample like this:

DUT ---> DSLAM --->PPPoE