安装php出现“/replace/with/path/to/perl/interpreter: bad interpreter: No such file or directory ”的解决方法

编译安装参数如下：

./configure \        --prefix=/usr/local/php \        --with-apxs2=/usr/local/apache2/bin/apxs \        --with-config-file-path=/usr/local/php/etc \        --with-mysql=/usr/local/mysql/ \        --with-libxml-dir \        --with-gd \        --with-jpeg-dir \        --with-png-dir \        --with-freetype-dir \        --with-iconv-dir \        --with-zlib-dir \        --with-bz2 \        --with-openssl \        --with-mcrypt \        --enable-soap \        --enable-gd-native-ttf \        --enable-mbstring \        --enable-sockets \        --enable-exif \        --disable-ipv6

遇到的错误如下：

Sorry, I cannot run apxs.  Possible reasons follow:
1. Perl is not installed
2. apxs was not found. Try to pass the path using –with-apxs2=/path/to/apxs
3. Apache was not built using –enable-so (the apxs usage page is displayed)
The output of /usr/local/apache/bin/apxs follows:
./configure: /usr/local/apache/bin/apxs: not found
configure: error: Aborting

解决方法如下：

找到apache目录下的apxs脚本文件，然后编辑它，把第一行的注释的地方修改为perl的可执行路径（首先要保证你安装过perl，没有安装请先行安装），如

yum install perl perl-devel

vi /usr/local/apache2/bin/apxs

#!/usr/bin/perl -w ####原来为 /replace/with/path/to/perl/interpreter