[pylon笔记2]Basler相机视频获取及转换

来源：互联网发布：有程序员转行的吗编辑：程序博客网时间：2024/04/28 21:55

1.The buffer was incompletely grabbed

Error: 0xe1000014 "The buffer was incompletely grabbed. This can be caused by performance problems of the network hardware used, i.e. network adapter, switch, or ethernet cable. To fix this, try increasing the camera's Inter-Packet Delay in the Transport Layer category to reduce the required bandwidth, and adjust the camera's Packet Size setting to the highest supported frame size."
将画面尺寸改小，或将Transport Layer里的Inter-Packet Delay选项改大即可。

根本的办法应该是打开网卡的巨型帧，在System Setting的网卡设置里将MTU设为9000。注意只有相机为连接状态时设置才有效。

2.缺少动态连接库

xxx.so--cannot open shared object file: No such file or directory

用ln将需要的so文件链接到/usr/lib或者/lib这两个默认的目录下边

ln -s /where/you/install/lib/xxx.so /usr/libsudo ldconfig

0 0