MIPI转换芯片 转接IC ZA7783A:MIPI DSI转RGB/LVDS芯片
来源:互联网 发布:达内软件靠谱吗 编辑:程序博客网 时间:2024/05/15 03:52
1 Overview
ZA7783 is a bridge chip which supports three kinds of display interfaces:
MIPI DSI RX Interface (1 Clock Lane + 4 Data Lanes)
LVDS TX Interface (1 Clock Lane + 4 Data Lanes)
MIPI DPI TX/RX Interface (PCLK + RGB888 + VSYNC + HSYNC +DATAEN)
The chip bridges these display interfaces in three working modes:
MODE1: MIPI DSI RX => LVDS TX
MODE2: MIPI DSI RX => DPI TX
MODE3: DPI RX => LVDS TX
Besides, there is also an I2C control interface (XCLK + I2C_SCL + I2C_SDA) for the host chip (AP or BB) to access ZA7783’s software registers.Analog IPs of ZA7783 are supplied by 3.3V voltage (typical). For Digital IOs, the host interface (XCLK + I2C_SCL + I2C_SDA) is supplied by DVDD18 (PIN32),while the DPI interface (PCLK + RGB888 + VSYNC + HSYNC + DATAEN) is supplied by DVDD33 (PIN45 and PIN59). Thus, ZA7783 is able to bridge AP or BB with 1.8V IO to RGB Panel with 3.3V IO. Besides, an embedded LDO converts 3.3V to 1.2V to supply the chip’s internal digital logic. In addition, an embedded POR implements a power on reset to the whole chip.
2 Target Applications
Tablet PC
3 Feature Description
MIPI DSI RX Interface
Compliant to MIPI DSI V1.01 and MIPI D-PHY V1.00
1 Clock Lane + 4 Data Lanes
Data rate up to 600Mbps per data lane (300MHz high-speed clock on clock lane)
2.4Gbps bandwidth on four data lanes in total, giving a display resolution up to 1366x768 24bpp @ 60fps
Only support MIPI DSI Video Mode (Non-Burst Mode with Sync Pulses) and all lanes are unidirectional from the host chip to the bridge chip
The host chip is required to provide continuous high-speed clock
Only support using all of the four data lanes, in other words, using part of them is not supported
Support multiple packets within a single high-speed transmission
Ignore received virtual channel field
Only the following packet data types are supported:
6'h01=Sync Event, V Sync Start (Short)
6'h11=Sync Event, V Sync End (Short)
6'h21=Sync Event, H Sync Start (Short)
6'h31=Sync Event, H Sync End (Short)
6'h08=End of Transimission packet (EoTp) (Short)
6'h09=Null Packet, no data (Long)
6'h19=Blanking Packet, no data (Long)
6'h2E=Loosely Packed Pixel Stream, 18-bit RGB, 6-6-6 Format (Long)
6'h3E=Packed Pixel Stream, 24-bit RGB, 8-8-8 Format (Long)
The other packet data types cannot be handled and must not be sent to ZA7783!
Ignore received ecc field
Ignore received checksum field
RGB565 Packed Pixel Stream and RGB666 Packed Pixel Stream are not supported
For a data lane, the connection of Dp/Dn can be exchanged
The order of the four data lanes can be configured
Dither function for converting RGB888 to RGB666
LVDS TX Interface
Compliant to LVDS Spec
1 Clock Lane + 4 Data Lanes
Support RGB888 and RGB666
RGB888: 1 Clock Lane + 4 Data Lanes
RGB666: 1 Clock Lane + 3 Data Lanes
Support NS Mode and JEIDA Mode
The polarity of VSYNC/HSYNC/DATAEN can be configured
For a data lane, the connection of Dp/Dn can be exchanged
The order of the four data lanes can be configured
Dither function for converting RGB888 to RGB666
DPI TX/RX Interface
PCLK + RGB888 + VSYNC + HSYNC + DATAEN
The edge of PCLK can be configured
The polarity of VSYNC/HSYNC/DATAEN can be configured
I2C Interface
An external clock XCLK should be provided (e.g. 26MHz)
Up to 400Kbps
ZA7783 is a bridge chip which supports three kinds of display interfaces:
MIPI DSI RX Interface (1 Clock Lane + 4 Data Lanes)
LVDS TX Interface (1 Clock Lane + 4 Data Lanes)
MIPI DPI TX/RX Interface (PCLK + RGB888 + VSYNC + HSYNC +DATAEN)
The chip bridges these display interfaces in three working modes:
MODE1: MIPI DSI RX => LVDS TX
MODE2: MIPI DSI RX => DPI TX
MODE3: DPI RX => LVDS TX
Besides, there is also an I2C control interface (XCLK + I2C_SCL + I2C_SDA) for the host chip (AP or BB) to access ZA7783’s software registers.Analog IPs of ZA7783 are supplied by 3.3V voltage (typical). For Digital IOs, the host interface (XCLK + I2C_SCL + I2C_SDA) is supplied by DVDD18 (PIN32),while the DPI interface (PCLK + RGB888 + VSYNC + HSYNC + DATAEN) is supplied by DVDD33 (PIN45 and PIN59). Thus, ZA7783 is able to bridge AP or BB with 1.8V IO to RGB Panel with 3.3V IO. Besides, an embedded LDO converts 3.3V to 1.2V to supply the chip’s internal digital logic. In addition, an embedded POR implements a power on reset to the whole chip.
2 Target Applications
Tablet PC
3 Feature Description
MIPI DSI RX Interface
Compliant to MIPI DSI V1.01 and MIPI D-PHY V1.00
1 Clock Lane + 4 Data Lanes
Data rate up to 600Mbps per data lane (300MHz high-speed clock on clock lane)
2.4Gbps bandwidth on four data lanes in total, giving a display resolution up to 1366x768 24bpp @ 60fps
Only support MIPI DSI Video Mode (Non-Burst Mode with Sync Pulses) and all lanes are unidirectional from the host chip to the bridge chip
The host chip is required to provide continuous high-speed clock
Only support using all of the four data lanes, in other words, using part of them is not supported
Support multiple packets within a single high-speed transmission
Ignore received virtual channel field
Only the following packet data types are supported:
6'h01=Sync Event, V Sync Start (Short)
6'h11=Sync Event, V Sync End (Short)
6'h21=Sync Event, H Sync Start (Short)
6'h31=Sync Event, H Sync End (Short)
6'h08=End of Transimission packet (EoTp) (Short)
6'h09=Null Packet, no data (Long)
6'h19=Blanking Packet, no data (Long)
6'h2E=Loosely Packed Pixel Stream, 18-bit RGB, 6-6-6 Format (Long)
6'h3E=Packed Pixel Stream, 24-bit RGB, 8-8-8 Format (Long)
The other packet data types cannot be handled and must not be sent to ZA7783!
Ignore received ecc field
Ignore received checksum field
RGB565 Packed Pixel Stream and RGB666 Packed Pixel Stream are not supported
For a data lane, the connection of Dp/Dn can be exchanged
The order of the four data lanes can be configured
Dither function for converting RGB888 to RGB666
LVDS TX Interface
Compliant to LVDS Spec
1 Clock Lane + 4 Data Lanes
Support RGB888 and RGB666
RGB888: 1 Clock Lane + 4 Data Lanes
RGB666: 1 Clock Lane + 3 Data Lanes
Support NS Mode and JEIDA Mode
The polarity of VSYNC/HSYNC/DATAEN can be configured
For a data lane, the connection of Dp/Dn can be exchanged
The order of the four data lanes can be configured
Dither function for converting RGB888 to RGB666
DPI TX/RX Interface
PCLK + RGB888 + VSYNC + HSYNC + DATAEN
The edge of PCLK can be configured
The polarity of VSYNC/HSYNC/DATAEN can be configured
I2C Interface
An external clock XCLK should be provided (e.g. 26MHz)
Up to 400Kbps
I2C Slave ID is 0x37
4 Functional Block Diagram
...
5 Pin Configuration
...
0 0
- MIPI转换芯片 转接IC ZA7783A:MIPI DSI转RGB/LVDS芯片
- 转接IC ZA7783A:MIPI DSI转RGB/LVDS芯片
- 转接IC LT8911:LVDS/MIPI DSI转EDP转接芯片
- 转接IC ICN6202:MIPI DSI转LVDS芯片
- 转接IC LT8911B:LVDS/MIPI DSI转EDP芯片
- 转接IC ICN6211:MIPI DSI转RGB芯片
- RGB转MIPI DSI-TC358778XBG转换芯片,优于SSD2828方案。
- TC358775XBG转换芯片:MIPI DSI转LVDS(单路/双路),替代ICN6202芯片
- TC358778XBG:RGB转MIPI DSI转换芯片,告别SSD2828,LT8918时代
- 转接IC NCS8801S:RGB/LVDS转EDP芯片
- 转接IC NCS8801:RGB/LVDS转EDP/DP芯片
- 转接IC NCS8805:RGB/LVDS转EDP /Scaler 芯片
- 【详细资料】ICN6202芯片MIPI转LVDS功能
- 东芝mipi转LVDS芯片TC358775XBG调试
- LT8912 业界新突破 MIPI转HDMI、MIPI转MHL、MIPI转LVDS最强转接IC
- 转接IC NCS8807:LVDS转miniLVDS芯片
- rgb接口->ssd2825rgb转mipi桥接芯片->mipi接口
- MIPI转RGB芯片ICN6211规格书详细内容
- java后台业务数据树形化展示(使用easyUI)
- 蓝桥杯-十六进制转八进制
- 设计模式--23种模式精华(七)
- Testflight 添加外部测试人员
- QQ腾讯第三方登录
- MIPI转换芯片 转接IC ZA7783A:MIPI DSI转RGB/LVDS芯片
- 【从零开始学线程】java synchronized
- Android4.4. 编译 错误 /bin/bash: xmllint: 未找到命令
- 如何构建一个最简单的electron应用
- Sping-boot spring-cloud学习地址
- 快捷使用Retrofit网络请求框架(get请求,post请求,上传文件)
- 在一个包含40亿个随机排列的32位整数的顺序文件中(注意随机排序),找出一个不再文件中的32位整数
- 讯飞语音识别SDK试用
- Java替换特定字符串中的特定子串