POJ-1887-Testing the CATCHER【最长不上升子序列nlogn】
来源:互联网 发布:日式装修 知乎 编辑:程序博客网 时间:2024/04/30 03:30
Testing the CATCHER
Time Limit: 1000MS Memory Limit: 30000K
Description
A military contractor for the Department of Defense has just completed a series of preliminary tests for a new defensive missile called the CATCHER which is capable of intercepting multiple incoming offensive missiles. The CATCHER is supposed to be a remarkable defensive missile. It can move forward, laterally, and downward at very fast speeds, and it can intercept an offensive missile without being damaged. But it does have one major flaw. Although it can be fired to reach any initial elevation, it has no power to move higher than the last missile that it has intercepted.
The tests which the contractor completed were computer simulations of battlefield and hostile attack conditions. Since they were only preliminary, the simulations tested only the CATCHER’s vertical movement capability. In each simulation, the CATCHER was fired at a sequence of offensive missiles which were incoming at fixed time intervals. The only information available to the CATCHER for each incoming missile was its height at the point it could be intercepted and where it appeared in the sequence of missiles. Each incoming missile for a test run is represented in the sequence only once.
The result of each test is reported as the sequence of incoming missiles and the total number of those missiles that are intercepted by the CATCHER in that test.
The General Accounting Office wants to be sure that the simulation test results submitted by the military contractor are attainable, given the constraints of the CATCHER. You must write a program that takes input data representing the pattern of incoming missiles for several different tests and outputs the maximum numbers of missiles that the CATCHER can intercept for those tests. For any incoming missile in a test, the CATCHER is able to intercept it if and only if it satisfies one of these two conditions:
The incoming missile is the first missile to be intercepted in this test.
-or-
The missile was fired after the last missile that was intercepted and it is not higher than the last missile which was intercepted.
Input
The input data for any test consists of a sequence of one or more non-negative integers, all of which are less than or equal to 32,767, representing the heights of the incoming missiles (the test pattern). The last number in each sequence is -1, which signifies the end of data for that particular test and is not considered to represent a missile height. The end of data for the entire input is the number -1 as the first value in a test; it is not considered to be a separate test.
Output
Output for each test consists of a test number (Test #1, Test #2, etc.) and the maximum number of incoming missiles that the CATCHER could possibly intercept for the test. That maximum number appears after an identifying message. There must be at least one blank line between output for successive data sets.
Note: The number of missiles for any given test is not limited. If your solution is based on an inefficient algorithm, it may not execute in the allotted time.
Sample Input
389
207
155
300
299
170
158
65
-1
23
34
21
-1
-1
Sample Output
Test #1:
maximum possible interceptions: 6
Test #2:
maximum possible interceptions: 2
题目链接:POJ 1887
题目大意:n个无重复的非负且不大于32767(short表示范围)的整数,求其最大的递减(非连续)子序列
题目思路:很裸的最长不下降子序列
以下是代码:
/*最长不上升子序列 POJ 1887*/ void init() { for(int i = 1; i <= tot; i++) S[i] = -INF; //注意初始值 memset(d, 0, sizeof(d)); } int BSearch(int x, int y, int v) { while(x <= y) { int mid = x+(y-x)/2; if(S[mid] >= v) x = mid+1; //注意看二分的变化 else y = mid-1; } return x; } void dp() { init(); int ans = 0; for(int i = 1; i <= tot; i++) { int x = 1, y = i; int pos = BSearch(x, y, A[i]); d[i] = pos; S[d[i]] = max(S[d[i]], A[i]); //max ans = max(ans, d[i]); } printf(" maximum possible interceptions: %d\n", ans); }
- POJ-1887-Testing the CATCHER【最长不上升子序列nlogn】
- poj 1887 Testing the CATCHER (最长不上升子序列)
- poj 1887Testing the CATCHER(最长下降子序列)
- poj 1887 Testing the CATCHER(最长递增子序列)
- Testing the CATCHER - POJ 1887 最长递减子序列
- POJ 1887 Testing the CATCHER(最长递减子序列)
- POJ 1887-Testing the CATCHER(dp_最长下降子序列)
- POJ 1887 Testing the CATCHER(最长下降子序列)
- poj 1887 Testing the CATCHER_最长上升子序列
- POJ-1887-Testing the CATCHER-最长递减子序列-DP动态规划
- POJ--1887:Testing the CATCHER (DP求最长非递增子序列)
- POJ-1887 Testing the CATCHER(dp,最长下降子序列)
- POJ 1887 —— Testing the CATCHER 最长下降子序列
- poj 1887 Testing the CATCHER 最长不升子序列
- 【最长非升子序列】北大 POJ 1887 Testing the CATCHER
- POJ 1887 Testing the CATCHER(最长非升子序列)
- poj 1631 最长上升子序列 nlogn
- POJ 1631(最长上升子序列 nlogn).
- C#程序调用cmd.exe执行命令
- Undo Related Wait Events & Known Issues (文档 ID 1575701.1)
- Tkinter实现带标签的记事本
- 轻松控制EasyUI-Tab选项卡
- Android studio将项目打包成签名安装包
- POJ-1887-Testing the CATCHER【最长不上升子序列nlogn】
- FJ的字符串
- Java properities 中文乱码解决方法
- 中断响应优先级和中断处理优先级的区别
- Android常用adb命令
- [机器学习]pegasos编译的错误
- 判断101-200之间有多少个素数,并输出所有素数。素数为一个大于1的自然数,除了1和它本身外,不能被其他自然数整除。
- 个人博客+移动端开发第0章(开发环境配置)
- WebKit之HTMLConstructionSite类组成